FRANKLIN Oil Pan Gasket, Part # RG-10366, FAA-PMA - Fits multiple engines

Description

FRANKLIN OIL PAN GASKET -
SILICONE
Our silicone rubber gaskets are made from aerospace mechanical grade AMS silicone
and
designed to withstand temperatures up to 400 degrees Fahrenheit.
Our gaskets
seal uneven and warped surfaces
,
eliminate corrosion
and
are
100% reusable
.
FAA/PMA
for the following engines.
FITS
:
Franklin engines
6A4-145-A3,
6A4-150 Series,
6A4-150-B3,
6A4-165-B3,
6A-335-B/B1,
6A-350-C1/C2,
6V4-178-B33,
6V4-200-Series,
6V-335-Series,
6VS-335-A/B,
6VS-335-A1A/A1B,
6V-350-A/B.
Part #:
RG-10366
One gasket.
Gasket is 1/16" thick.
Reusable.
INSTALLATION AND MAINTENANCE
1.           ALL SURFACES MUST BE CLEAN AND DRY,
NO LUBRICATION OF ANY TYPE.
THIS ALSO
INCLUDES THE THREADED HOLES IN THE CASE.
2.           INSTALL GASKET -
DRY
TORQUE
20   TO  25
INCH POUNDS. TORQUE
GRADUALLY
AROUND AND ACROSS COVER TO PULL DOWN
EVENLY OVER THE ENTIRE COVER.
DO NOT OVER TIGHTEN - over tightening makes the gasket bulge or squeeze out.
3.           PERFORM ENGINE RUN AND CHECK FOR LEAKS,
4.            IF THERE IS A LEAK,
DO NOT CONTINUE TO TIGHTEN.
THIS WILL ONLY MAKE THE LEAK WORSE.
- REMOVE THE GASKET AND EXAMINE ITS CONDITION.
IF IT IS STILL SERVICEABLE, WASH IT
BRIEFLY
IN HOT SOAPY WATER, RINSE & DRY OFF.
RE-INSTALL USING THE ABOVE INSTRUCTIONS.
5.            TO REUSE THE GASKET, CLEAN AS DESCRIBED  IN (4)
CAUTION - DO NOT OVER-TIGHTEN!
Over tightening makes the gasket bulge out or "pooch" out.
If this happens then back off on the torque.
TO REUSE GASKET:
Wash gasket in hot soapy water.
Rinse thoroughly and dry all surfaces.
Re-install using the above installation instructions.
Proudly made in the USA.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
USE
CORK
? GET REAL!
REAL
Gaskets that is…
REAL
Gaskets
Tennessee
is a manufacturer of silicone rubber gaskets for aircraft,
automobile, and motorcycle engines.
Our silicone rubber gaskets are made from aerospace mechanical grade AMS silicone,
designed to withstand temperatures
up to 400 degrees Fahrenheit and to last the
life of the engine.
Our gaskets
seal uneven surfaces
,
eliminate corrosion
and are
100% reusable
.
We manufacture valve cover gaskets for:
Aircraft:
Continental, Franklin, Lycoming, Pratt & Whitney and Wright radial
piston aircraft engines.
Automobiles:
Ford, GM, Mopar, Porsche and VW automobile engines
Motorcycles:
BMW, Harley-Davidson, Suzuki, BSA, Ducati, Moto Guzzi, Norton,
Triumph, Saab and most other motorcycle
engines.
If you are tired of oil leaks, then a silicone rubber gasket is the only way to go, and
REAL
Gaskets Tennessee is the only place
you can get
“The Original”
silicone
rubber gasket.
MADE IN THE
USA
.